Houston-The Woodlands-Sugar LandHarris County
A Spring floor that passes under 1.0 x 109 ohms
Server halls, network operations space and dispatch floors in Spring run on equipment that never powers down, so the hard part of a floor here is rarely the coating. It is finding the hours. The record for Spring shows data centers.
Spring, and what gets built here
The demand in Spring comes from equipment density rather than population, and these are the operations behind it, each with the document it was verified against.
TRG Datacenters is adding a second 110,000 sq ft building to its data center on Spring
TRG Datacenters is adding a second 110,000 sq ft building to its data center on Spring Cypress Road in Spring.
Uptime is the constraint
Two things change on a Spring job with live racks in the room. The band is often set higher for the safety of anyone working near energized gear, and the handover window becomes the plan.
The document behind a Spring job
ANSI/ESD STM7.1-2020 is the one worth reading first for work like this. The test method for qualifying a floor material before installation and for accepting and monitoring it afterwards.
Printed two ways, same document
You will see this cited as STM7.1 and as S7.1, including on manufacturer data sheets. Many report templates still print S7.1. They refer to the same floor resistive characterization method.
Questions from Spring
What about the raised floor we already have?
The resinous system goes on the slab underneath it. Whether the access floor stays, comes up in sections, or gets replaced is a scoping question we would want to walk before quoting. Send us the layout.
How soon can you get to Spring?
Tell us the timing you are working against and we will give you a real date rather than a placeholder. Crews work Harris County alongside the rest of the Texas schedule. Send the details.
Do you handle the whole job in Spring or just the coating?
The whole job: removing what is down, preparing the slab, the grounding network, the system itself and the cure schedule around your operation. Prep and grounding are where most of the work is. How it runs.
Sources
- Conductive and dissipative ESD epoxy technical data sheet, resistance and cure figures
Cited here for the conductive flooring/coating resistance band. The ESD Association's own consumer-facing page states only the <= 1.0 x 106 ohm ceiling with no stated floor.
www.arcat.com - FAA-STD-019, floor resistance and grounding requirements for FAA facilities
Lightning and surge protection, grounding, bonding, and shielding for FAA facilities and electronic equipment.
staticworx.com
Every number on this page came from one of those documents. Send us the room and we will tell you which of them your floor has to answer to.